How A Paper Mill Found The Right Mechanical Seal For A Pulper

Sealing pulpers is tough. 

Is there anything tougher to seal than a bottom entering pulper? Rotors on these machines take a beating from market pulp bales and recycled material, causing large radial shaft deflections. Traditionally, seals have been packed, allowing for leakage, loss of product, wet floors, and thousands of dollars wasted on downtime and gearbox repair. 

The maintenance department at New Page decided they weren’t going to take it anymore.  The leaking seal on “Slab Broke Pulper” was simply costing them too much. They determined that the seal they needed would have to be fast and easy to install, very low maintenance, and withstand the heavy shock and vibration that occurs during normal operating conditions.

New Page decided to install a John Crane fully split mechanical seal with compression ring rubber bellows. The rubber bellows would add flexibility and shaft deflection so angular misalignment and run outs were tolerated.

The mechanical seal they chose accepted:

• Radial shaft movement of 0.125”
• Shaft run out up to 0.020”
• Stuffing box waviness up to 0.030”
• Axial end play up to 0.060”
• Out of squareness box face to the shaft of up to 0.100”
• Temperatures up to 180° F
• Pressures up to 80 psig
• Speeds up to 1,800 rpm