Gate Valves and Knife Gate Valves: Isn't One Just Sharper?

Author: Sara Peters | October 16, 2014 | Category: Valves

Knife_Gate_ValvesAs one of the resident bloggers here at Crane, I get ideas for blog posts all the time. The other day, an idea for a post about the difference between a gate valve and a knife gate valve came across my desk. “Seriously?” I said. “Isn’t the only difference that the knife gate has a sharper disk?”

I should have known the difference was not so cut and dry, pardon the pun. While the gate valve and knife gate have many similarities, there are characteristics to these valves that make them inherently different.

What makes them similar?

Walworth_forged-steel-gate-valves

Gate and knife gate valves are primarily for on/off service. Using these types of valves to regulate flow is not recommended because when fluid pushes against a partially closed gate vibration occurs, eventually wearing and eroding the seat and disk. For that reason, these types of valves should be either completely opened, or completely closed.

These valves are also designed to open and close slowly to protect from the effects of water hammer.

Both types of valves can be found in applications that involve:

  • Slurries
  • Heavy oils
  • Non-flammable viscous fluids
  • Wastewater
  • Clean water
Orbinox_Series_20

What makes them different?

The differences between them are vast. First off, yes, the knife gate valve DOES have a sharpened disk (thank you very much). This is meant to sever any stringent solids that may keep the valve from closing and causing it to leak. But there’s more that makes their designs quite different.

The biggest difference between these two types of valves is that gate valves are built to ANSI standards while knife gate valves adhere to TAPPI standards. Therefore, dimensionally the gate valve is wider, flanged, and ANSI pressure rated. It also has API leak tightness standards must be met. They're bi-directional, and commonly used in steam applications as well as fluid applications. The gate valve is only available with metal seats.

Another significant difference between an ANSI gate valve and a knife gate valve is in the packing gland area.  A gate valve will have a v-ring packing set that seals the shaft attached to the gate, while a knife gate valve has a packing gland that seals around the gate.

A knife gate has a very thin profile compared to its bulkier counterpart. It's also uni-directional (though bi-directional is an option on some), and comes in either wafer or lugged body, no flanges. The seats on the knife gate valve come in everything from metal to resilient types.

Two of the knife gate's biggest advantages knife are weight and expense. A 16” knife gate valve will typically weigh less than 300# while an ANSI gate valve will be in excess of 1200#.  The cost of the valve is similar to the weight difference as well.

Got a question about valves in your facility? Ask us about it! We gladly provide technical assistance to businesses in Wisconsin and Upper Michigan.

Like what you read? Click here to subscribe to this blog!

Sara Peters

Sara Peters

Sara leads Crane Engineering's blogging team, coming up with fresh stories and insights for our readers to apply to their every day work.

Join your peers!
Subscribe to our blog for more tips, tools, and troubleshooting advice delivered right to your inbox.

Comment

Subscribe by email

Contact Our Team