What's Wrong With My Mechanical Seal? 4 Common Problems And Causes

Author: Sara Peters | February 27, 2015 | Category: Mechanical Seals, Troubleshooting

What's on your seal faces? Heat checking? Coking? Blistering? The appearance of these blemishes on your seals is a sure sign the seal is on its way to failure, if it hasn't already. Read on to understand what causes these problems and how to address them.

HeatChecking_-_smallerHEAT CHECKING

The appearance of radial cracks originating from the center of the metal or ceramic ring is referred to as heat checking. According to the Fluid Sealing Association (FSA), these cracks in the seal face act as cutting edges, which eventually wear out the seal because of the consequent scraping action.

Possible causes of heat checking include an inadequate amount of seal face lubrication, inadequate cooling, or vaporization at the seal face.

To protect against heat checking make sure an adequate amount of lubricant is applied to the seal. You can also go a step further and confirm adequate coolant flow at the face to ensure self-generated heat is carried away from the seal face.

325-1

COKING

Coking leaves a black build-up, or abrasive sludge on the atmospheric side of the seal. This build-up causes rapid wear of the seal faces, usually caused by oxidation. Signs of coking tend to develop when the seal is operating under excessive temperatures or by using a dirty or contaminated flush, among other things.

Flushing the seal from a cool, clean external source, or even switching to a hard seal face material that can withstand oxidation helps to prevent coking. If signs of coking appear, use steam to remove sludge and debris from the atmospheric side of the seal. 

IMG_0194_-_smallPITTING AND CORROSION OF SEAL

Chemical attack is a culprit for pitting and corrosion of mechanical seals. Seal failure caused by chemical attack typically results from using the wrong seal materials for the operating environment, as evidenced in the picture to the right. Pitting can also occur when the seal runs dry, causing gases to escape and implode on the seal face.   

To combat corrosion, understand the fluid's chemical breakdown, then switch out the seal materials. When selecting seal materials, always consider normal operating conditions and non-process activities, such as cleaning, steaming, acid and caustic flushes. 

333-1BLISTERING ON SEAL FACE

Blistering is a symptom of thermal attack, and is characterized by small circular sections that appear raised on the carbon seal faces. Blistering is a common cause for seal leakage because the blisters cause separation between the seal faces during operation. As we discussed in our most popular eBook, 36 Ways to Kill Your Pump, seal faces are incredibly flat and any amount of contamination (such as blistering) will cause the faces to not align and leak. Blistering is also a common occurrence in seals that start and stop frequently.   

The causes of blistering typically generate from highly viscous fluids. When the seal heats up, the oil from the viscous fluid is rapidly driven out from the pores in the seal face. Improper cooling and circulation on the seal face will also increase your chance for blistering.  

Eliminate frequent starts and stops of rotating equipment that contain mechanical seals to help prevent blistering. If possible, substitute a non-porous seal face material to prevent the oil from penetrating the seal face in the first place. 

Got an issue with a seal that doesn't fit any of these common problems? Ask us about it! We gladly provide technical assistance to businesses and municipalities in Wisconsin and upper Michigan.

36 Ways to Kill Your Pump EBook - Download Now

Sara Peters

Sara Peters

Sara leads Crane Engineering's blogging team, coming up with fresh stories and insights for our readers to apply to their every day work.

Join your peers!
Subscribe to our blog for more tips, tools, and troubleshooting advice delivered right to your inbox.

Comment

Subscribe by email

request-a-quote